Crack Image Quality Indicator (CIQI)
X-ray radiography is commonly used for the detection of cracks in metal parts such as those used in the aerospace industry. A typical application is for weld inspection where volumetric flaws such as pores, inclusions and flaws resulting in volumetric features such as suck-back, and under-cut are detected. The x-ray inspection of welds is also meant to detect cracklike or tight flaws and cracks that provide linear indications. X-ray inspection reliability is based on POD of the desired minimum size cracks in suitable crack specimens. The demonstrated x-ray technique is then assumed to provide the same level of POD in actual part inspection. However, in many cases the POD demonstration specimens and setup are not similar to that used for x-ray inspection of actual parts due to the lack of appropriate demonstration crack verification toolsets. The ideal demonstration toolset shall match the parts to be tested in alloy type, part geometry, thickness and expected crack morphology, target crack size, locations, and orientations. If a qualified CIQI tool is available at the time of part inspection, x-ray technique sensitivity for crack detection can be verified for the part inspection setup. A CIQI toolset could provide simulated known crack sizes and have the same material and geometry for x-ray inspection to that of the actual part. Ideally, the appropriate crack specimen can be used to make a CIQI tool but manufacturing specimens with cracks of controlled morphology and size for different x-ray applications with different material alloys and thicknesses may be impractical and cost prohibitive. Therefore, cheap CIQI toolsets with representative cracklike discontinuities may be desired by industry. The Crack Image Quality Indicator (CIQI) is a technology readiness level (TRL) 6 (system/sub-system model or prototype demonstrated in an operational environment). The innovation is now available for your company to license. Please note that NASA does not manufacture products itself for commercial sale.
X-Ray Crack Detectability
NASAs software technology uses an Image Quality Indicator (IQI)-based model that can predict whether cracks of a certain size can be detected, as well as a model that can provide appropriate conditions to optimize x-ray crack detection setup. Because this modeling software can predict minimum crack sizes that can be detected by a particular X-ray radiography testing setup, users can test various setups until the desired crack detection capabilities are achieved (predicted) by the modeling system. These flaw size parameter models use a set of measured inputs, including thickness sensitivity, detector modulation transfer function, detector signal response function, and other setup geometry parameters, to predict the minimum crack sizes detectable by the testing setup and X-ray angle limits for detecting such flaws. Current X-ray methods provide adequate control for detection of volumetric flaws but do not provide a high probability of detection (POD), and crack detection sensitivity cannot be verified for reliable detection. This results in reduced confidence in terms of crack detection. Given that these cracks, if undetected, can cause catastrophic failure in various systems (e.g., pressure vessels, etc.), verifying that X-ray radiography systems used for NDE can detect such cracks is of the utmost importance in many applications.
Stay up to date, follow NASA's Technology Transfer Program on:
facebook twitter linkedin youtube
Facebook Logo Twitter Logo Linkedin Logo Youtube Logo